Hangzhou Hengli Transmission Co., Ltd.

Hangzhou Hengli Transmission Co., Ltd.

Professionalism, focus, production, research and development, salesEP brand industrial conveyor and transmission series belts

current position:HOME»news»Press Room»

Factors of normal operation of high temperature resistant conveyor belt device

Article source: unknown Popularity:发表时间:2018-04-28 14:41

First of all, it must be ensured that there is no problem with its own conveying device. The high-temperature conveyor belt is only a hub, and its operation still depends on the conveying device. The quality of the device is the first factor that determines whether the belt can operate normally.

Secondly, whether the belt is matched with the conveyor and whether it is suitable for transporting this kind of goods are all factors that determine the normal operation of the conveyor belt.Whether the belt is in good condition, whether the problem has been dealt with, and whether the goods are placed on the conveyor belt properly will directly affect the operation of the conveyor belt.

Furthermore, the operator should have the professional knowledge of operating the conveying device and repairing the conveyor belt, discovering the problem, repairing and disposing it in time, and stifling the harm in the cradle.

The normal operation of the belt will affect the production efficiency of the enterprise, so attention should be paid.

The peeling of the high temperature resistant conveyor belt is mainly due to the low adhesion and strength between the cover layer and the core. The main reasons for the low adhesion and strength between the two are as follows:

After the 1st core paste was plasticized, it was stuck with dirt when passing through the reversing roller.

2 The core paste can not be combined with the batter well.

The precipitation of plasticizer in the 3 core paste reduces the adhesion and strength between the core surfaces.

Fragile materials also limit the belt speed.When the high temperature resistant conveyor belt and the conveyed materials pass through the rollers, the powdered materials should be conveyed at a sufficiently low belt speed.The lower belt speed can prevent fragile materials from jumping and breaking at the loading and unloading points.Heavy materials with sharp edges should be conveyed at a medium speed.Because the edges will excessively wear the surface of the conveyor belt, especially when the charging speed in the conveying direction is significantly lower than the speed of the conveyor belt.Increasing the belt speed can reduce the bandwidth and conveyor belt tension.However, while bringing the above benefits, it is also necessary to weigh the possible shortcomings of conveyor belt wear, material bounce, air flow resistance, large impact of the supporting roller, and the reduction of the life of all parts of the conveyor belt.

Recommended Products

Ranking of similar articles

Latest news articles